Quote:ClassicDrogn wrote:Think, drill head, as in industrial well drilling. If the bit blades are 2 - 3 inches across and interleaved properly, she could cut a hole between 6 to 10 inches across.
I'm not really visualizing the configuration Taylor's got the shields in, I'm afraid. At first I thought she was setting them up like the wheels on a pitching machine to accelerate a blaster shot, but then you've got her walking it over to the door, and talking about ctting off her hand if it gets out of alignment... is it like a Barrier Punch / Giga Drill Breaker combo thing? Some kind of glorious abomination of razor-edged buzz saw whirlwind? Something else entirely?
And again, like I said the first time... Dat multitasking!
For personal safety the set should set about 15 - 20 inches from the end of her hand while still in line with her forearm.
This will allow spalling debris to fall to the floor relatively safety. The debris will be curly, and sharp. Do not step on it.