RE: Art for CmptrWz's "Hybrid Hive: Eat Shard?"
08-20-2019, 06:01 PM (This post was last modified: 08-20-2019, 06:05 PM by classicdrogn.)
08-20-2019, 06:01 PM (This post was last modified: 08-20-2019, 06:05 PM by classicdrogn.)
I think it's a fine idea, but I'll have to ask CmptrWz first. Also, that necklace as it stands is kind of a killer for conversion out of Blender since it uses the dupliverts and fit to curve modifiers, but I can make sure a single link is there unmodified easily enough, or a simple cylinder extrude with a bump/normal map to create hexagonal panel lines would probably do the job as well for less triangles.
Busy and on the wrong operating system ATM, but I'll leave the tab open as a reminder.
Edit: It will also give me an excuse to try to fix that GD crease in the neck of the bust that only began to bother me after the images were posted.
Busy and on the wrong operating system ATM, but I'll leave the tab open as a reminder.
Edit: It will also give me an excuse to try to fix that GD crease in the neck of the bust that only began to bother me after the images were posted.
--
‎noli esse culus
‎noli esse culus